Sensational-Adelaide.com

normh wrote: ↑

Wed Aug 29, 2018 5:49 am

Anyone have an update on the build? any photos? The slider would have move if TimTam can see it from KW & Pulteney.

North Terrace and Pulteney.

Photo wasn't as bad as I thought it would be (will still take one later today)

I don't know how common fire extinguishers are on building sites, but it looks strange to see the one sitting on that bit of dirt floor that hasn't been levelled off or concreted over yet. It doesn't look big enough to be able to deal with any fire that might start in that area, and there don't seem to be extinguishers scattered round the rest of the site.

Hey SBD, Looking out the window it appears to not be an extinguisher, but a traffic bollard (I knew the photo wasn't the best):

normh wrote:Anyone have an update on the build? any photos? The slider would have move if TimTam can see it from KW & Pulteney.

Taken this afternoon, just for you








Sent from my iPhone using Tapatalk

THANK YOU. currently in Qld for awhile and missing the build.
especially given I listed to roads that never intersect as corrected by timtam

whatstheirname wrote: ↑

Wed Aug 29, 2018 11:29 am

Hey SBD, Looking out the window it appears to not be an extinguisher, but a traffic bollard (I knew the photo wasn't the best):

Bollard.PNG

So it is. It still looks out of place on a dirt floor under the beginnings of a skyscraper.

As promised:

Pikey wrote: ↑

Tue Aug 28, 2018 6:49 pm

rad wrote: ↑

Tue Aug 28, 2018 10:06 am

If you google AFS logicwall you should find the information regarding the walls to the Western side of the building.

In my experience these are a pain in the arse and are essentially cfc sheeting each side and are known to blow out during the pouring of concrete.

Interesting to see they went with formed rather than precast walls for the perimeter. I'm sure once the neighbouring building is passed and the podium complete, they'll move to a jumpform system.

looks like you were correct Pikey, looking at the photos put up today, the south wall looks like it is precast and so only the west wall is the logicwall AFS. Possibly because is it so close to the other building?

Looks like that final basement bit is going to be poured today.

From today:







Basement




Round the back



Sent from my iPhone using Tapatalk

Floor has been poured and they are ready for the next level... also RAMP